The DMT Tone Control is a passive dual mode tone control that can operate in either HIGH PASS or LOW PASS modes greatly expanding the instruments tonal possibilities. Micro switches on the circuit board provide the user the ability to select one of two different frequency ranges for both high and low pass modes. Easy installation with no capacitors or other parts needed. Replace the tone control in you guitar with one that you will actually use!
DMT Dual Mode Tone Control Features:
- Operates in Low Pass or High Pass modes.
- Each mode has selectable frequency range.
- Tuned specifically for electric guitar
- Works with all Single Coils & Humbuckers
- Completely passive-No battery needed.
- No affect on tone at full clockwise setting.
- Simple three wire installation.
DMT Dual Mode Tone Control Specifications:
- Shaft Material/Type: Aluminum/Split Knurl
- Spline Count/Type: 18 Spline/Coarse
- Spline Height: 3/8".375"
- Threaded Shaft Material/Length: Brass-3/8" (.375")
- Threaded Shaft Diameter/Thread Pitch: 3/8" (32NEF)
- Required Cavity Depth: 1.1"
5 Reviews Hide Reviews Show Reviews
Tried on my p bass with a sd3 quarter pounder. Sounds great if you are looking for a REALLY bright tone. Definitely cuts through the band mix. I'm stumped on wiring this to a SSS strat with the Gilmore mod. I can't find a wiring guide anywhere because these are wired different than regular pots. Looked everywhere on the interweb and haven't found info. The wiring diagrams included are completely different than standard pots. Anyone do this before?
This is a great replacement. Sounds amazing. Very easy to wire in as well. Love the tone so far and I haven't even tried adjusting the little high low switches yet. Pickups on middle and bridge (position 4) And mid pot up and bridge down is the Best sound. I couldn't be more pleased. I'm about to order another to try it on my p bass. I'll leave a bass review when I test it out.
For the last 18 years I've bought and sold no less than 6 amps, trying to achieve the tone I was looking for but never quite getting there. I bought and installed this, in conjunction with the v-treb, and I have finally gotten the tone AND control that I have been looking for. What a difference the DMT makes in tone control. Being dual mode is great for guitars with humbuckers that have coil taps. Wiring this in place was very quick and simple. If you're looking to gain flexibility and get the tone you're looking for, look no further.
No BS, does what it says. Incredibly useful to me in recordings.
I have used these in several guitars that I have built in the last couple of years and love the results. They broaden the tonal capabilities tremendously